Totally depends on the surface. Hard question to answer. I started a few years back making them out of 2.5mm, I believe, and people didn't like how thick they were, so I made them thinner, now at the 1.4mm I seem to get an overall approval. This does shorten the life span of the aluminum's. The stainless last a long time, probably longer than you will own the vehicle, unless you are running on a super abrasive surface. According to many of my buddy's who are chassis sponsored, they don't like to run them in fear they may change the projectory of the vehicle on take off from a jump. The other reason some can't run them is contract prohibits it. I personally haven't seen this projectory problem happen, but it could be possible, and there will be a slight drag with anything that hangs below the surface of the chassis. Hope this helps!
Here is a pic of the 410.3 with my skids...

No ,but u can measure them on the instruction book in the legend if the are longer then the one in the pics then it is but i did not have issuies

When u put the new skids on can u use the same screws or do u need longer ones ,those skids look sweeeeeeettttt

I see that the front one is attached under the front bars of the bumper how is it doing that?

What wheels offset does this truck take, losi, sc10, sc10 4x4? Thanks

Losi scte, zero offset

Just purchased the aluminum from Sumo and will let everyone know how they hold up

I have the same question, do the regular screws work and how does the front skid go under the bumper? any advice on setup.

Also looking to get another set for a used SCT410 on ebay. Aswild - is $175-$200 a good deal for a roller?

thx

Good price for a used one...lightly used ones go for a lil more. The chassis tells the story.

The kit is 350 on sale an u have to buyRX,servo,combo, body,does it come with everything an how does the bottom look id say 175 would b a great deal if u need to buy a RX/tx then 100 bucks for that so 275 plus battery an the things that were over looked when sold

Bottom in normal shape on 1 but seller looks like he took great care of it. $170 for roller plus 8 wheels/tires 50% tread.

There is another sct410 that has been built except for the shocks. Never used. Just the kit almost completed currently for $195 bid...

Just would need motor/esc combo and a reciever. already have the rest... thx for your help! Was thinking of running this one on 3s/4s on a low KV Xerun setup for practicing on the track and bashing...

Would there be any interest in 7075 alum shock towers from M2C racing? I have already bent two of the stock rear shock towers. Just purchased the cf, but I prefer to run alum. If there is enough interest, they would probably make them. Idk if they need to be 4 or 5 mm.

Just installed my CF in my tekno sct410.3 look great thickness was 5MM.

I seen the one for 195 there was 22 bidders ,i went with castle pro sct 3800 kv,
Its cool witht the cumputer app to do all the adjusting i turn that esc way up an it was flying on 2s but i am running 14 tooth pinion i. I should have went hobby wing one from feirce solution for 40 bucks defrence-

Did u put the super glue @ the edges?

U should check out that durango on the forum thats a good deal an cool truck