I have seen this problem before. The leads soldered into the timing board are barely long enough to pass through the PCB and don't get soldered very well.
You can press the 2 PCB's together while re-soldering the posts and this may fix your problem... it did for me. I wish they would leave the pins long so they could get soldered properly and then clip off the excess. simple soldering 101.

You may need to install in compatibility mode.
Uninstall the current program.
Right click on the .exe install file and select compatibility mode.
You will be prompted to choose and older OS and just move forward with the install. don't close the troubleshooter till everything has installed.

You may have hurt the motor by revving it with so much boost. I take it you had no load on the motor at the time? The ESC might be sensing that there is something wrong with the motor. Make sure that your 2s battery is fully charged. Try unplugging the sensor cable and then turn it on. If no go, wire up known good motor and see if it's all better. If still no go, you may now have an ESC problem.

If you have already updated your ESC, the LED card may no longer be compatible. Get the LCD card and you should be ok.

Make sure you didn't accidently change model number on your transmitter and then re-calibrate the ESC to your radio. If it calibrates normally, it should work. If it shows a problem while calibrating, you may have killed the forward mosfet pack. Double check all your soldering as well.

Man, you are on a roll! Did you stay at a Holiday inn last night?

I haven't updated the esc. The card has never worked.

is the mmm 17.5 the good one to have for blinky touring car? or hows the v3? or maybe somthing else?

MMM 17.5. I use the same motor with a speed passion Reventon Pro for stock racing using the stock timing board at max. so far it has work well for me no lack of power or speed.

The MMM is the better of the two.

How did you know??
The couple in the next room were really going at it.

Sounded like trimming a body shell with a file. "waa-wa-waa-wa-waa-wa"... LOL

A number of issues I'm having :-

Car running Speed Passion motors which were part of Combos sold with either the Reventon S or R speed controllers. The brakes are really poor, even running 20% drag brake. Club mates have suggested that is actually the motor and not the esc.

Reventon R and S have poor reverse. It either actually doesn't work at all, or has a delay.

I like the smoothness of the esc but the problems listed are making me seriously consider selling all my Speed Passion equipment and buying another brand as my racing enjoyment is being spoiled. I would like the SP advisor Solara on this thread to advise on these in case I can make some improvements.

hi!

I changed my ESC software reventon pro and put the muchmore Fleta 4.0, but would return the original SP software, anyone know if it is possible to do this?

thanks

From what I've read on this board, you must use the smart LCD program card to correctly set your brakes. The ESC comes with a low default brake setting.

Also with the new software there is no reverse in blinky