SC10 4x4 Thread
More pictures of the 4 gear mod.

Added a third slot to hold my Tekin Pro4 motor. Used the clear template to get it lined up.

Spindle installed on the aluminum motor plate.

Spindle held by a 3mm flat head set in a countersunk hole to ensure it does not move.

Added a third slot to hold my Tekin Pro4 motor. Used the clear template to get it lined up.

Spindle installed on the aluminum motor plate.

Spindle held by a 3mm flat head set in a countersunk hole to ensure it does not move.
Last edited by Shark413; 12-30-2013 at 01:50 PM.
Tech Regular
iTrader: (14)
Joined: Sep 2011
Posts: 319
From: Newton, NC
Hey guys, are there any recent mods that are must have? I had to put my sc10 4x4 down for over a year now and Im looking to get back in it. The last I knew was Mantis' 2 stage shocks and cdiff which I have V1. I also have saddle packs and the center brace. Once i get up and going again I'll got to the new version of the cdiff, V2 or V3 if its out.
First stab at the V3 Mod1 48t spur gear! THIS IS JUST A PROTOTYPE!!!
The outside ring is a dust shield for the balls, it will not completely seal off but will help in keeping dust out.
Also note that there is no center bearing on this particular one , i still need to do some testing, its a long drawn out process but the end result will be nice!
The outside ring is a dust shield for the balls, it will not completely seal off but will help in keeping dust out.
Also note that there is no center bearing on this particular one , i still need to do some testing, its a long drawn out process but the end result will be nice!
Hey guys, are there any recent mods that are must have? I had to put my sc10 4x4 down for over a year now and Im looking to get back in it. The last I knew was Mantis' 2 stage shocks and cdiff which I have V1. I also have saddle packs and the center brace. Once i get up and going again I'll got to the new version of the cdiff, V2 or V3 if its out.
The latest hot thing to do if your tractk conditions warrant is to go with an ultra lite setup with a shorty lipo up front.
Shark would be a good person to look at his mods to see what is all involved.
9Turn might. give him a jingle.
What did I miss?
Tech Regular
iTrader: (14)
Joined: Sep 2011
Posts: 319
From: Newton, NC
I have saddle packs and chassis brace. Mantis' 2 stage pistons, V1 c diff, and ack bar all from when he first came out with them.



5Likes




