Hmmm..., the HW 150A ESC is 58mm long according to published specs. I sure hope you're off by a couple mm.

http://www.teknorc.com/tekno5/wp-con...rt_Truggy2.jpg

Mamba Monster systems fit with about 4-5mm in between the ESC and motor. The ESC pad was made for Mamba Monster and smaller ESC's.

The distance you are looking for is approx. 395mm.

Thank you greatly

So tempting to get one of these bad boys. You tekno guys are making it difficult for me to save money lately :P

So yeah, really sorry about that...

Hey Tekno,

In testing have you guys run a 2000kv truggy motor? If so what tooth pinion did you use?

Aww, you have gone and made the entire company feel bad. Now apologize, buy the truck, and all will be forgiven.

I assume ET48 pretty much same as EB48 for ESC area.

I had a HW150 in the EB48, but it was very tight. As in so tight that the sensor wire was basically sandwiched by the body/side guard, and on the other side the front center drive shaft is mm's from the ESC. That was the only config that would even fit with motor.

I put a HW SCT Pro in there because I was afraid something would get damaged or shorted.

I would go with a different ESC if I was you. Just not enough room for HW150.

Too bad becasue I like the 150 also, great ESC. Works really well with Tekin motor!

Yes. They send out the preferred plus codes every now and then if you a SS member. I got mine on the 13th of this month.

Only if your a SS member.

I was just kidding Tekno, take my money!!!

Yes tekno take my money

Have the eb48.2 upgrades been implemented into the truggy? Like the angled rear gearbox etc...

What it say its got all the upgrade the eb48.2 got