Wow! Amazing skills Mel! Might have to send you a lid soon!

Thanks .. and sure thing .. send one on over

Very sharp sir!

Very nice. Is this the stock body?

Yes, that is the stock body.

i'm using a RB v12 blast, the clutch bell spins free but once i tighten down the screw it binds, am i missing something, tried so many shims but no matter what i do the second i tighten down the screw for the bell it binds.

Well I just picked myself up a new EB48.2 and a NB48. I was wondering what parts will transfer from car to car or will they be completely different?

For relative purposes the complete front and rear ends will work with each other...except front caster blocks (NB =15* and EB=10) and rear ring gear (offset for the NB) and rear diff case.

Arms shocks towers hinge pins hubs axels/outdrives are the same

I may be wrong but that's what I can remember....im at work so...no cars or manuals in front of me lol

It sounds like you need fewer shims behind the 5x13 bearing. This will effectively extend the shaft out so there will be a little play when you tighten the screw. Alternatively, you can pick up some 3x5mm shims to place into the end bearing (effectively extending the shaft). Hope that helps.

Tekno RC has the instruction manual posted on the site now

http://www.teknorc.com/tekno5/wp-con...structions.pdf

Quick question. Did you guys test the kit setup at REV?

Yes we did. And Thunder Alley, ProLine track, CVRC, SDRC, and a couple others.

Thanks! it did help, everything is running nice and smooth.

just about done, i'm not the best painter in the world, but it does the job done.

That paint jobs very original and effective, well done.

Real sharp!

Nice.. How's that Blast?