Flip a coin

Are you serious?

Probably. They'll likely make the .2 out of an inferior plastic that will be approximately the same quality as the stock ones.

These work with the .2 as they are virtually the same car.

2 Questions!

Are they going to be in yellow?

And when can we expect to be able to order some?!?!

You dirty dog! Glad to finally see them out though. Tired of drooling over them on Jro's car.

hopefully someone can help. My B4.2 pushes really bad under any amount of power when i let off it turns great. I wanna start from scratch so if anyone wants to give me some setup ideas i will try them. The track is a higher grip track that fades to the dryer side by the end of the night. Lots of big long turns anf a few really tight turns.

Thanks
Jared

I too had that issue, up until last week. I ended up upgrading to the kit below. Most of what you have will end up being replaced other than the rear wheels and the front wheels will need to be shimmed. You can reuse your electronics, including the motor. Will likely have to swap pinions due to the smaller spur included in this upgrade kit:

The funny thing is you're still slow

This man speaks the truth!

I would love to have a rb6, if my local tracks carried there parts. I ran a team c tc02 evo buggy and loved it but got this car in a trade and have no money in it so im trying to make it work.

Try hartsons most recent setup for starters

B4's are great, I'm not trolling the thread. I have 2, and a T4 as well and they're not going anywhere anytime soon.

Take a look at your diff, if it is too tight it will push pretty good.

http://www.rctech.net/forum/electric...ng-racing.html