TF2 Owners,

Check this out. You can have overdrive and underdrive for your TF2 by doing a few mods to your transfer case.

http://www.rccrawler.com/forum/rc4wd...%2A%2A%2A.html

mga sirs,
ask ko lang, scalers, aside from esc, ano pa po ang i-waterproof? thank you.

Mainly servo and reciever at kung meron ka light unit and winch control board. Basicaly water and electronics doesnt mix

thank you sir , how about elec. motor pag may vent holes. ok lang ba?

Sir pinoy_rc, ok lang at puwede mabasa ang brushed motor.

Sir Dusty Road, sige ok yun pampalamig after natin mag comp sa init.

Ang brushless ba pwede mabasa?

Yan ang di pwede, kelangan i-WP.

Sir ilang mm ang pwede ilagay sa shocks ng tamiya cc01, naka 1.9 na tires yung akin, sumasayad kase sa body yung gulong, stock shocks po gamit ko ngayon.

Oo nga, portal axle dapat talaga para scale na unimog talaga. Nagiisip pa si sam kung kukuha ng portal axle.

Sa soler sir ako bumibili ng brass tube. Masyado malambot ung copper tube sa autosupply!

Pwede ako magdala this sunday trail sa PnW ng brass tubing. Kung sino me gusto. Sizes are 1/4, 3/16, 1/8.

Paano po winawater proof ang brushless motor?

Waaaahhhh its so frustrating.... Bought a 3ch flysky reciever just to found out it cant be used for my also newly purchased 3racing winch..... Any suggestions? At this point spending on another controller is not an option. Pahinga muna sa gastos... Hehe... Had purchased quite some unusable accessories lately.

mga sirs,
are there any problems ba sa receiver? regarding winch. nasa listahan ko kasi yung 3racing winch system. baka pwede pa-advise sa mga kapwa scalers anong brand maganda na winch system at anong receivers ang intermittent. thank you and more power scalers!.

mga sirs,
san po makakabili ng corrosionX for waterproofing purposes? nasa malls ba ito?
or any by-product common for waterproofing ng electronix.

mga sirs,
san po makakabili ng corrosionX for waterproofing purposes? nasa malls ba ito?
or any by-product common for waterproofing ng electronix.

Check this out bro http://www.youtube.com/watch?v=0vIWFnHJewA
He used a servo as a clicker for the 3racing winch switch. That is you have a spare servo around and don't mind doing a little diy

Jimuni.ss,

Have 2 spare servo. Will take alook at it...

Also would like to ask what setup do you guys run on your wraith? Just finished building mine. Placed a brushless motor on it. with the stock axial rx and tx and stock gearing. Hirap macontrol ang crawl niya. Also using a HW 60a Esc with drag brake. Parang pag mabagal nanginginig yung takbo niya. Di siya smooth?