Thanks Gene for all the build tips.
Got my body all painted up and hopefully it'll fit the BR6. New Buggy comes in today I hope. Its like Christmas I tell Ya.

Gene, Is Intech coming out with a truggy and 1/10 electric buggy? I checked the site and found this:
http://www.intechracing.com/product_cat.asp?darea=34
Dang, would be cool if they did a truggy too.

.

What receiver pack is everyone using?

I am using Racers Edge 1500 Life battery, I had to trim out one corner out as so the wires wouldnt rub thru as I routed the leads facing the center to reciever box.

I may end up going try the Reedy Life Battery 1300

Started my build and was installing the option 12 degree caster blocks and notice that the stock ones appear to be less caster....maybe 10 degrees? I actually stood both up against each other and the stock plastic definitely has less caster angle.
Gene, do you know the actual degrees the stockers has? Also, will Intech make some different aluminum caster angle?
Build is solid so far with only one screw missing. Plastic seems better than the 5 Evo and quality is top notch. The bulkheads are super beefy, and fit/ finish is up there with the best. Well done Intech.

ARE THE WHEEL NUTS COURSE OR FINE THREADED

1.0 fine thread. just checked last night

2300mah lipo protek pack.

The stock caster blocks are 10' (20' total caster with 0 inserts).

The BR-6 kits are now back in stock.

hmmm, I guess I'll install the stockers until they decide to make the 10 degree ones in aluminum. I like the bling

Use the alum ones for large tracks and very bumpy tracks. Use the stock blocks for smaller tighter or smooth tracks.

cool, will do. should be able to try it out this weekend. Thanks Gene

The kyosho style?