Looks like my intel was probly right. Makes sense, as it was from a pretty credible source. Was told they were supposed to ship from Slovakia begining of this week.

Is anybody selling their T3 '12?

just preorder from amain hobbies

this will be my first xray, going from a ta05-ifsv2

Brand new Xray T4's are in one of those big boxes on this ship headed to the USA ...

Are these any good for stock racing SP13.5TMMM + SP Cirtix?
Intellect Lipo battery CC5800V6 5800mAh 60C 7.4v
Or is more mAh and higher C needed?

With former cars I owned, not XRay, I used to drill the shock caps with 1mm and did not use the shock foam inserts.

Anyone any experience on this matter as to XRay cars? (especially T3/T4)

Xray offers both with and with out vents in the shock caps. Personally I run with a vent hole in the cap...

I heard it was on this one;

Did not buy the T4 yet.
Which ones are in the kit, with or without vent hole? Partnumber?

What are the partnumbers of both?

So XRay has these shock caps with the vent hole already in 'em?
If so that would be nice. Don't have to do the drilling myself then.

Using the shock foam insert or not?

Sent you a private message.

i just went through the manual and it looks like vented... you can go to the website and look for yourself for parts number etc

Hi!
Over the weekend, my xray TQ & win the Hungarian electronic Championship stock category.Speedpassion cirtix & Speedpassion 13.5T 4.5FDR (ETS Rules) My car ran basic carpet setup.A changed the final leg down stop front 6,5mm rear 5.5mm of the car ran the fastest lap of the day.

Okidoki.

Using the shock foam inserts or not?

308332 - COMPOSITE SHOCK PARTS - REBOUND HOLE
or
308331 - COMPOSITE FRAME SHOCK PARTS 4-STEP

Not what I was looking for.

In the end it seems as if, like with other cars, I have to drill the shock cap (part number 308333) myself.

Any comment on using the shock foam insert? I mean as to using it or not.

What are the preferences as to the use of 3- or 4-hole piston?