our truck, does it has the same offset as the losi SCTE ?

what if tires and ride height are correct and it still wants to come swing around in front?

Hey guys,
Those running the 8mm mod on the rear camber links... what length are your turnbuckles? (between cups, like in the manual instructions ?mm).
I'm running mine inside hole on shock tower, and outside hole on the fibre c-hub mod.
Cheers.

I am running 7mm, outside hole on rear tower, and outside hole on c-hub riser which lines up with inside hole on hub. Also running short camber link in front with 1mm shim under front ball stud. 2.0mm sway bars front and rear. Blue front spring front and white front spring in rear. 32.5 front shock fluid, 27.5 rear, single x-ring, bladder, no boots, 6mm ext. limiters. Front shock middle hole tower, outside on arm. Rear shock inside hole on tower and arm. V2 C-diff with 5 pins, 7k front diff and 5k rear. FT ackerman rear holes. Exotek chassis, 23mm ride height. Tazer wheels on 3mm offset hazard wheels run on med traction outdoor track, wet to drying.

measured 5mm
between the ball cups

inside on tower & outside on C hub

Hey Smithy, I run mine inside on the tower and inside on the c hub bracket.Inline with the inner hole on the stock rear hub carrier just 8MM higher

Borak. I was able to get mine to do what I wanted by using a lower bite tire up front. It really helped calm the truck down. So far the sway bars and the lower bite tires up front, have helped me the most.

well i run barcodes all around on my indoor track.. maybe try stock tires up front for a push?

Maybe a Double Dee

+1 on the Barcodes @ OCRC. Perfect tire for that application

dont have any double dee's.. what about a holeshot? all i really got is stock's at the moment.. not sure if i want to spend the extra 30 bucks for another set of tires

Borak, What is the surface your running on?? Other Than OCRC?

ok, well i raced last night. The truck ran night and day better than any other time I ran it. Rotated the right amount in the corners and squared up well. I actually really enjoyed the truck. I ended up TQ'ing and winning with the truck. He is the basics of my setup.

Front:
locked clicker
Over Drive 19t pulley
Yellow springs
Camber link inside with 5mm
shocks top center and bottom outside
2 oz lead to the left and right of the servo
FT Ack in the rear holes
Arms Level
AE Team Kit Tires
1/2 oz left front and stick pack
2.2/yellow sway bar
32.5 wt oil
1.2 piston no bladders

rear
front blue springs
NO 8mm mod
Zero camber shims
Camber link middle hub and outside on tower
Shock Middle top and inside bottom
2.0/Blue sway bar
27.5 weight oil
1.2 piston no bladders
Exotek Front Slipper Locker w/ VTS Outside Sliper
15/62 gearing with a Tekin 550 2 pole 4.5 motor
Proline Sniper Tires.
arms just below level


I went from last place last week to TQ. It was way better.

Are you going to install the team set-up ?

Congrats!! Wildcat Great feeling to have the truck work the way you want it to