did you try what i told you with the rear springs use the f blues with the 8mm but only us 2mm on the tower

are you geting lose on brake or on the gas

the squaring up is coming out of the corner. When I enter the corner, the rear just swings. How does the wheel base affect the tracks handling. Would a shorter wheel base help.

I have the blue fronts on the rear and the 8mm mod. But we got rained out last saturday, so i have to wait for the weekend

I dont use brakes, lol. only in the air....

The one way with slipper pulley very easy to turn to three modes with adjust the lock nut,4 wds mode,half one way mode and full one way mode.very good for racing thing.The silver thing is a heat sink hold water or othering for the motor plate no need any fan..

The one way with slipper pulley very easy to turn to three modes with adjust the lock nut,4 wds mode,half one way mode and full one way mode.very good for racing thing.The silver thing is a heat sink hold water or othering for the motor plate no need any fan..

im going through everything now. so far front end with belt off spins super free. gear mesh is good. im gonna check out the rear end and see how well that spins.

it seems to me you are in the right temp rang my tekin is 160-170 at 95-100 out side temp i run the 4600 no chang in temp 13t or 14t

what is your tensioner setting

Are those legal?

thats it i think, but i think its to loose... i just checked both trannies with out the belt attached and they spin real free. i looked at the belt and it rubs the guide. all along the bottom of the guide and it droops down on the top in some parts.

im running the 19t pulley in the front with the settins at 3-2 in front and just about a 1 in the rear.

yes

where did ya get these ?

Add the pic of the cnc pom M1 48t spur gear

Remember guys, never change the length on your esc power wires

i use 5in the rear and 1 in the front