I have gallons on my engines (not sure how many, but new this season) and I can not recall any time that I have started one of them without being on my Competition Heat!!!! I REALLY think it has and will extend the life of my engines, and man...they start up like a dream everytime

http://www.amainhobbies.com/product_...ge-Motor-Mount
i like this motor mount.

Those are my favorite mounts. You have to drill a hole for the extended. They make it in standard also.

dose it bolt up at the back tank post?

no..as he said you need to drill a hole.

thanks i skipp it now

Just get the non extended one or the Losi one.

can you tell me where i need to drill?

They come with instructions as you need the mount first and I think you need it mounted to one side first so you can mark it for drilling but its all explained with the mount.

Fits: LOSI 8ight Buggy or Truggy
LOSI 8ight 2.0 Buggy or Truggy
LOSI L8 Dirt Oval








FEATURES: This Mount is CNC machined from
7075 aircraft grade aluminum and Black Anodized. These are designed
with a base mount and removable top blocks. Once the mount is installed
in the vehicle and the gear mesh is set you can remove and reinstall the
motor without resetting the mesh.
Another new feature is be flipping the top blocks from front to back you can
move the motor forward 2mm. This will allow you to run a standard 3 clutch
shoe setup without using an excessive amount of shims.


The extended arm is secured through the existing fuel tank hole in your chassis
so you do not have to drill any new holes.

Extra mounts can be purchased separately so that other motors
can be swapped out quickly.

++ Mount can not be used with Roto or Pull start motors ++

INCLUDES:
(1) Base Mount
(1) Set of top blocks
(1) Fuel Tank Post
(1) 5-40x 1/2" Alloy Flat Head Cap Screws
(8) 5-40 x 1/2" Alloy Allen Head Cap Screws
(4) M3 lock washers (used with screws that hold the top blocks to base)


SPECS.
Material: 7075 Aircraft Billet Aluminum
Weight: 35.83 grams (base, fuel post and 2 top blocks - no hardware)

Instruction Link: KPI-215

Hardware Kit Link: KPH-030

no new hole in it to be made

Thats good..I use the Losi one and KingHeadz on my Associated which had the instructions on how to fit

You don't need to drill any holes, this has been the case since the first one.

They give you a tank post with the mount.

No holes needed, the only thing kingheadz made where you needed to drill a hole was the extended rear brace.

Correct, it just bolts right up. I'm not sure what the other two are talking about.

mine is several years old and i had to tap a hole. That's all i am saying i believe it was for a RC8. I do see the fuel tank post with this one. Just decide if you want the extended or not. I am not crazy about the losi quick change mount.

Well that's the problem, it was far a RC8. The kingheadz mount comes with everything needed, no drilling needed. Please don't confuse people when comparing the losi to a AE product.