ilanstylz,

i sent you a pm with everything i am selling. i hope you can help me out.

Replied, hope it helps as its not a guaranteed sell, just a little bit better to scroll threw and read for the buyers.......

You should also post that you sold some of the stuff that the factory team comes with darryl like the whole saddle pack setup stuff. For those buying the factory team, that can be important as that is one of the main changes.

Try selling at your local track ...

Because of the huge popularity of the Sc 4x4 class at Trcr use roller's sell the same day or couple days after .

No local track near him.

no there are not any local tracks near me i am in the middle of no mans land.

will this al fit in the ft kit lay out?

yes i have the same speed control on the other side and it clears the belt tunnel, just cant use the 2 screws on the belt side on the fan, but 2 is still good.



this was before i straightened up the wires a bit hah.

thanks

Thinking about upgrading to FT kit?

i hve the older kit with the ft upgrade kit in it

Get the factory team kit only if you wanna be a G with a pimp ride!

i had the factory team mounting setup with my ft sc10 4x4 but i didnt like it.

Back from a good day at the track, although I had quite some issues with traction rolling in the high speed sweeper at the end of the straight. Track is astro turf, so high grip. I run the FT version, setup as per the manual. 540 can, saddles, yellow rear springs in rear, no 8mm mod etc. Tires proline hole shots M3.

Any idea on where to start for reducing traction rolling? At low speed corners I have no issues, can be fairly agressive....

Are you using the yellow front sway bar?