2.5mm, 2.0mm, 1.5mm hexes, 5.5mm nut driver, 7mm nut driver, 10mm nut driver, 17mm wheel wrench.

thank you,

Is the 1.5mm for that small screw that holds the hinge pins in ??

Where is a 10mm nut driver used? I can't for the life of me think of where it would be used on this car. The rest of the list makes sense.

in the battery compartment that bolts onto the chassis i believe

You dont need a nut driver for those bolts.

10mm driver would be for a nitro engines nut for the flywheel?

Just waiting on the custom stickers being made
Loving this body compared to the punisher!!

Yeah, sorry. Bad habit, I run both.

I'm soon ready with my RC8.2E and now I must choose which motor and ESC to buy. I have looked at Tekin, LRP and Castle Creations. What have you others racers used and what are your experiences?
What is best and why: low KV or high KV?


/Frazze

There have been 100's of posts on this topic already. Check the rc8be or any 1/8th thread.

My Kit didn't come with any of the Shock boot Washers (89352)

Do you guys know what it's measuring for the servo Saver? It says 7mm but man does this look tight. (I know servo saver tight and this thing is 1mm from locked down under the 7mm measurement.

7mm is way too much. 2-3mm tops is where i am

It says 7mm in the manual. from AL collar nut, to bottom of plastic servo saver.

The measurement given is the actual spring compression, not how much is sticking out of the end of the nut on the other side.



Edit: I'm just going to use your 2-3mm on the bottom threads and bag it. Thanks Bohdi

Built my 8.2e Tonight.

Kit was missing:

All 4 Shock boot collars
(at this point I started paying very close attention so I did not lose the following)
2 3x8 screws
1 outdrive o-ring.

Awww...

Either way. Very involved build. Very pleased to be done. Now i'm waiting on a Backordered Tekin RX8 / 1700kv Combo.

You ArE doing to love this buggy! It is butter. Some people swear to get the std b plate to reduce the amt of steering but I actually prefer the low b plate on the e buggy but cannot stand it on my nitro