I had the same problem need to put more in it
When I opened it up it was like it was gone
I just added and now it's fine

Norcal Hobbies had it's first asphalt race today and it was rad

TC6 was totally dialed in the main when the traction went down about a .5 second/lap

Geared 54/96 with revtech at 1 notch back from full timing for 3.55 rollout and was pretty fast but could use little more torque

Guess I noticed that during the qualifiers it had less steering but towards the main steering for me increased so might try something during qualifying to have steering then also

Running solaris mediums. Most we're running Team Powers 36R

Wonder what I'd notice if I was running same setup with TC6.1

Will post setup if anyone wants it?

Great car

Too much reading.....not enough pictures!

i want to order som spares for my tc6.1, does the 6.1 steering block fit on the old tc6 c hub?

These are both three holes pistons?
If so, what is the difference between the two?
Is there any noticable difference in the characteristics as to behaviour of the car when racing?

And same question when compared three holes with 2 holes kit #3.

I see LOSA5045/5046/5047/5048. All three holes. It gets more and more complicated.
Which ones to use? Racing on asphalt, most of the time low grip. Some tracks medium grip.
Or is it all too much of a hassle and just go with the kit #3(3/64")?

What brand pinions and spurs best to use on the 6.1?
Preferably supplied from Hong Kong.

LOSA5046 are the correct ones.

Please post setup ... great help

Nice! Foam tire racing! I do miss stock foam....

17.5 blinky setup

It was totally dialed in the main. Not really sure how my motor compared to the two leaders but one of them said I was catching them. Unfortunately I got too far back early on to dice it out with them but a 3rd place finish with a bunch of great 17.5 racers was fine for me first time out racing sedan in 8 years

Can't wait to run mod in the near future

I will try the Team Powers 36R tires next time to see how they do since they are the Reedy tires.

Later

http://www.rc-mushroom.com/advanced_...ort=1a&page=11

Do these fit for TC6/TC6.1?

FYI, It seems like Tamiya x-rings don't seal the tc6 dampers properly. On the bench, it felt like they were getting air in them immediately. I threw some blue schui orings in there, and it seems much better.

-Mike

Those should work fine. If you have a spur/pinion alignment issue, you will have to cut the motor shafts flat-spot back a little.

lol...I actually didn't even notice that the flat spot wasn't far back enough but pinion didn't slip ...lol

Is the ballast weight kit stackable? I need to reach a 1550g weight for VTA so Ill need two sets.

https://www.ssl-stormerhobbies.com/c...ns&pn=ASC31296

Im using the Zeppin pinions on my TC6 and they work just fine but flattening the motor shafts helps in giving more clearance from the belts.