Me too......... Having a good time doing it.

Question for you guys who have had the previous models. The bird's foot looking spacer between the supension mounts and the bulkhead......these seem pretty flimsy to me. When I install them, they crush a bit, and the mount ends up not being square. Has anyone else noticed this? I decided to put some metal suspension shims I had from another car in there. I'm curious to hear what you guys have experienced.

Thanks

There is an Error in the setup, the Steering Bellcranck and Steering Link values are swapped.

1,1,1.5 are Reflex pistons, usually AE #2 with 40 oil should be a good start.

This was the case on TC6 manual, we talk about this a while back.
Was this not corrected on TC6.1 manual??

THose clips work ok up front when running no toe. any mismatch from the front to the back of the inner pin and the plastic clips just deform and do not hold a setting. Most of us have either done what you have done or switched to the 12r5 bulkhead washers.

YEs the TC6.1 manual is Ok.

Thanks Seb, did you get your yet?

http://www.teamassociated.com/pdf/ca...ndoor_2011.pdf

Steering Link in this setup is 7B and Steering Bellcrank 2B??? Look at the setup sheet closely or is something in my eye???

We are not talking about Keven setup sheet, but the TC6 manual had mistakes between the steering link/bellcrank.

http://www3.towerhobbies.com/cgi-bin...&I=LXVSW0&P=7#

These?

Yeah, I thought they were cheaper at Amain but I might be mistaken.

Just getting back into on road. What servo is recommended? Looking to stick with savox.

This servo from Savox is recommended and many use them.. its low profile so it won't hang off the edge of the chassis and it is a good mix of speed and torque. Not a bad price either.

http://www.savoxusa.com/Savox_SC1251...avsc1251mg.htm

Not yet. But i've downloaded the manual.
I'm waiting january when it will be available in France at SMS.
Sébastien.

Looking at the T6.1 manual,,how much rear toe-in can we set???
Also,are the rear hubs different from the T6??? I don't see 1 degree hubs for the rear on the parts list
Thanks
idbdoug