R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 11-22-2011 | 03:38 PM
  #7752  
RCmayor's Avatar
RCmayor
Tech Elite
iTrader: (9)
 
Joined: May 2003
Posts: 2,745
From: Overland Park, KS
Default
Originally Posted by gguertin145
I just switched to the hex front conversions and have a question. I bought the new jconcepts nuts for the front they are serrated and I am using the de wheels. I don't have enough room for any socket to fit around that nut without hitting the wheel in the front... Rear ones have plenty of room.

Is there a special tool for this, I see the jconcepts nuts have indents around them? What is everyone using for the front wheels?

Thanks!
I had the opposite problem. The AE front hex wheels didn't have a problem but the Losi 22 rears I couldn't fit a nut driver in. I ended up grinding the JC serrated nuts down to 5/16". It wasn't hard to do, just grind away the high spots on the hexes then go a little more and it is right at 5/16".
RCmayor is offline  
Reply