Originally Posted by
Maxxingout
I saw yours and bigjayjay1, very nice. I was just looking for ways people have wired up there esc/motors, not that there arwe to many ways to do it.
Frank, I can't tell in your pic if you used 10 or 12 g wire? Is one recommended over the other or either or will work?
It's 12g Novak wire and I tried a fed different configurations for the wire and esc and ended up following what was posted on the serpent site. The esc and motor wires have to lay down to fit under the body so there's not really many choices. I did have to punch a new hole in the tray where the esc sits to route the esc receiver wire. But other than that I don't think there are many choices. I would like to see some pics too
