Just about done with my B44.1 build . Ran in to an issue while installing the motor . My 18 tooth pinion does not reach the 81 tooth kit spur gear . I pushed the motor in all the way and I have about a 1mm gap between the pinion and spur . What is up ? Do you need a specific brand of pinion to run with this buggy ? I think I have a Robinson Racing pinion .

Perhaps I installed the motor mount cam the wrong way ? But it only seems to slide in one way so I am pretty sure that is not the problem . What is the little set screw for ? Got to be honest , not to sure about how this motor mount works . What is to keep the motor for sliding back and forth after you set the mesh ?

I am running a 8.5 Turn Novak Motor so I though 18 /81 would be a good start for gearing ? Any thoughts or suggestions on that ?