hello,
I have read this entire thread and it helped greatly in my SC10 4x4 build. I am going to put in my RX8/Novak 550 5.5t/Spectrum RX/TX Monday&plan to go to the track after a quick test run outside. I watched chris's VID while building as well as all the TIPS on the 1st page of this thread&other tips for the build. I am going to read the OFFICIAL thread after this but i have a few Q's, and will just start with my 1st 2q's now, so that I am not overwhelming with Q's.

-I do not know if I am going to have the slipper issue, until I run. But, what is the correct Measurement in MM, for the SLIPPER THRUST SPACER suppose to be?? I know they were possibly machined wrong, so I would like to know before hand, if I need to add any washers. Also, if i know the correct measurement, I will know how many washers I need to add.?.

-I am going to get the HT slipper pads, but for the inner Stock pad:
Does it have to line up perfectly in the HEX slot on the inside? It is very hard to get it to stay perfectly in the slot while sliding it on. I guess i could put alil black grease on the inner Slipper Pad, but does it have to sit perfectly in the HEX, or is it ok, just being on the inside of the SPUR?
AND, when I get the HT pad, am I only suppose to use HT pad on the outside?? I think I read that on the 1st thread.

THX and i will have more Q's after these are answered.