Originally Posted by
alexrckid
Yep J-DUB's plastic hubs work well. But if you're looking for aluminum hubs that accept the 16mm bearing, KHZ is pretty much your only option.
Originally Posted by
miket
I believe you can enlarge the hole on the stock axle carriers to accept the larger bearing. I think you could use a dremel tool and a sanding drum to enlarge the hole.
Bad idea IMO. Not only do you need to open the diameter to 16mm, you also have to deepen the race to 5mm. Trying to do all of that by hand with a dremel is way to inaccurate IMO. You will end up out of round and the bearing will end up cocked in the race. Not good.
