Originally Posted by Redharris

Hi....I got my HobbyWing (ver 2.0) Xerun 120 Amp ESC/Motor combo 2 weeks ago.
Team Cobra sent me some software to unzip and load into my 2 in 1 program box, ( which I did).
My DeskTop says it is "Hobbywing USB Link V1.62".

When I open up the Software and Plug my 2 in 1 program box, the Hard Ware Version is HW310 V1.0
The Software Version is V1.06_100512.....

I unplug the 2 in 1 program box from the Computer.
I then plug the ESC into the 2 in 1 program box, plug in my battery and turn on the power.
The program box says V1.06_100512.
I press "OK' button. The programmer flashes "esc software ver 10_091218a_t" and then goes into the mode that allows me to set parameters of the ESC. I have the following options.
1 Running Mode
2 Drag Brake
3 Voltage Protection
4 DRRS Punch
5 Brake Force
6 Reverse Force
7 Initial Brake
8 Neutral Range
9 "AMTS" Timing
10 Overheat Protection.

Thats it.....No Boost or Turbo settings. Guess I did SOMETHING wrong. I dont know what I did incorrectly. The Instructions that came with the kit are no help. How do I get the Turbo and Boost settings to become Active?

Question.....Can I plug the 2 in 1 Program Box into my computer via USB,,,,,AND,,,,,plug the ESC into the Program Box,,,,,,AT THE SAME TIME?...It seems like that is the way it should work, but I have not done this yet, because I am not sure if it is advisable to do so. Again,,,,the Instructions are not much help....