Originally Posted by
RustyOne
I have just fitted one of these on steering.
Are you saying it won’t last on lipo.
http://www.jrradios.com/Products/Tec...D=JRPSZ9100HVT
Z9100HVT High Voltage Ultra Torque Servo
Specs
Size Category: Standard
Type: Digital
Application: 1/8, 1/5 on-road, off-road surface vehicles steering
Torque: 480 oz/in (2S Li-Po)
Speed: .12 sec/60°
Length: 1.58 in
Width: 0.82 in
Height: 1.57 in
Weight: 2.6 oz
Bushing Or Bearing: Bearing
Bearing: Dual
Motor Type: Coreless
Connector Type: JR
Gear Type: Metal
Gear Material: SuperSteel™
Voltage: 7.4V (2S Li-Po)
Deadband: Surface optimized
I have heard a few horror stories with these servo's on the 8T. Good luck though.
As far as the 7940 throttle servos for speed..I would much rather run a 7955 or even 7950 at throttle for the strenghth and durability. Just peace of mind to know you have that much tourque at throttle.
With the problems guys have had with these 8T dieing throttle servo's , (mostly setup) just better to be safe than sorry on race day