no idea ..the crank is new and the rod is the older type with the slightly smaller bush diameter for the crank pin(it's a match for the crank anyway)..Like I said the rod is also brand new and I have two other rods with less than a gallon on them..all 3 rods come with wrist pins and there is a pair of circlips for the piston too..check if it's the same..ask mark at massive I should..if it's a yes and I think it will be I'll do the lot cheap cheap..

edit...I should say actually that I fitted the crank and rod into my gen5 7 port and ran one tank through it before swopping it out for a GX crank and rod..so technically crank/rod/wristpin have 1 tank on them..not actually nip...