Originally Posted by
irosss
I just bought a micro t and i'm wanting to mod it already.
i'm most likely going to convert it to aluminum & carbon fiber.
but for the brushless system i want to figure out if i get the
Losi 11.1V lipo(LOSB0874) will it fry my
Xcelorin 10250Kv Brushless (LOSB9595)
and since im going brushless i have to get a new receiver, will i be able to use a
AM Receiver with 3-Wire Connector: Micro (LOSB0809) or will that get fried?
Dude I hear terrible things about the 3 wire AM receiver when mixed with a brushless system. You can do better with Hitec 3 wire micro servo. Go 2.4 ghz if possible on the tx/rx. Check out the cheapo setup at HobbyKing. The receiver is tiny and will fit the Micro-T if you take it out of the case. You can also get into brushless WAYYY cheaper than using that Losi system. Check out microtforum.com. Those dudes over there have it dialed.