Originally Posted by
HyperB5
I just compared it to a new one I have still in the box. it stops in exactly the same spot as his picture! then, with a little more push, it goes past the o-ring that is down inside the crankcase neck and sits just fine!
+1 You just haven't pushed it in all the way, mine was just the same way. I made sure the carb pinch bolt was out of the way and squeezed it in w/ my thumb then tightened the pinch bolt while holding it in place.
BTW this break-in is a breeze! You warm weather guys have it so easy, my last one was in 30 degrees, it's now in the 50's. 5 tanks thru it so far and I'm lovin' it. Will finish break in tomorrow.