Originally Posted by
justsomeguy
bit of a thread jack..
I have the Hyperion EOS 6061i ac/dc charger... Read the manual, hooked up a 5000mah 2S Zippy and off I went. Charging at 5.0 amps..It was done when I got home.
Today I tried it on my mini battery. 1600mah 3S zippy... Its been hours since it started. The charger says it is charging at .16 amps.
Shouldn't it be 1.6 amps?????
I thought I went through the menus right...Is it seeing something wrong with my battery or something?
Thanks
Tony
First you left your lipo charging unattended
BAD idea! Second, how many hours?? It's a normal part of the charging to see .16amps on some packs as it's almost full but on a pack that small it should have terminated the charge within an hour I'd guess ( I have a 610inet)
Read your post again..did you set the mah for the pack to 1600 or did you put in 160 by mistake as that would take forever and set the charge rate at .16 amps automaticaly.