Originally Posted by
air8
Say someone messed up a rear hub on his truggy and the hobby shop only has 1.0 rear hubs. Which of the three holes in the 1.0 hub would be the same as Hole-B in the 2.0 hub?
2nd hole in....the extra hole in on the inside inside and is used in conjunction with the shorter links
Originally Posted by
vladconnery
As documented in the thread. The front wheels rub the A arm. I switched to the AKA rims however I still have rub.
My question is will the 2mm hub extenders cure this?
Also has anyone ever put there truggy on a Hudy system. If so did you notice with the 1's pointed out in the rear toe plate. Did you notice you were actually at 5 degrees toe and not 3. I put in the .5's in pointed out and I was still just shy of 4 degrees.
the stock sheet is Wrong for the rear's....here's the proper #'s
Rear Toe-In adjustment
Position....Insert #....total toe-IN....REAL total
Inside........1.............1............1.65
Inside........0.5..........1.5.........2.15
Middle........0.............2............2.70
Outside......0.5..........2.5..........3.25
Outside......1.............3.............3.80
Rear Anti adjustment
Position....Insert #....total Anti....REAL total
UP..........1...............3............3.15
UP.........0.5.............2.5..........2.60
Middle......0.............2.............2.05
Down.......0.5.........1.5...........1.50
Down.......1.............1.............0.95
Originally Posted by
CREWMAN
they kept the footprint of the chassis the same and extended it on the rear behind where it hooks onto the box so its a direct drop on for 1.0 or 2.0 the 2.0 actually fits a little bit better.
