Originally Posted by
houston
carefully take it apart and inspect for any problems . if it is really gummed up then yes soak it in fuel or wd40 also works great . that one i just cleaned out i needed to actually scrape all the gunk off
When i had it apart lookin at it the sleeve and piston looked clean. It was slightly sticky on top of the piston but there Wasnt any gunk on it. Should i still clean it or just seal it? it just seems really tight . Little excessive. Would it hurt it to heat it to 300 with a heat gun? Btw why are my collet just free spinin on the shaft. I have to pinch the collet with a pair of pliers to make it snug on the shaft. thanks for helping me you wouldn who i was if you seen me we met