R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 04-30-2009 | 07:23 PM
  #6561  
xlt69er
Tech Adept
iTrader: (2)
 
Joined: Oct 2008
Posts: 111
Default
Originally Posted by MassiveMods
Did you measure the big end bushing ? it should measure 4.988 ID mm

Ok maybe you are lucky , please run the engine hotter from now on . Just put it on the ground and begin to play with it

Cheers MM
Just to be safe as soon as I fully break the engine in I am going to replace the connecting rod. For only around $20 the insurance is worth it.

The pinch is still very extremely tight.
I will have the buggy finished somethime this week and I will let you know how the break in procedure went. (keeping it above 200 but under 260?)

Thanks for looking after me and letting me know that the instructions included with the motor is not the best procedure.
xlt69er is offline  
Reply