I broke my SC10 chassis and top plate last nite racing and made a plate today to fix it.

I ran this plate all day over the broken chassis and it works perfectly.

I did have to buy a new top plate for $7 tho.

I didn't have to change the chassis and everything on it.

Just bolt the plate to the 2 original bulkhead screws then drill 2 new holes under the servo (pull the servo first!) and put 2 new screws with nuts in the new holes, remount the servo and go racing again.

Should take about 10 minutes, no new chassis and no complete rebuild.

I hand made several of these plates to help you guys that WILL eventually break your chassis in the same place.

You can get one to fix your chassis or get one to prevent breaking your chassis and top plate.

Or you can go get an aluminum plate at the hobby store, cut it, bend it, drill it, countersink it and then bolt it on but you won't be racing the same day that's for sure!

$20 shipped for one of my "F N Racing Stuff" plates.
Get your paypal ready.