R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 07-07-2008 | 10:28 AM
  #3664  
Mudblaster
Tech Apprentice
iTrader: (27)
 
Joined: Oct 2006
Posts: 56
From: Plainfield, IL
Default
Originally Posted by vyt666
guys,eed help on my my 5 port(standard)what should be the main problem if my fully broken in engine is flaming out?i started it yesterday to finished the run in procedure,due to vibration the plug that connects the rx pack and the receiver disconnects and my buggy(hyper 7 )gone wild and crashed on a concrete wall,good thing is there is no any damage on my kit,then i let the engine to cool down,then after some few minutes cooling down, my engine starts to flame out i dont know what reason why my engine is acting like that,since it hit the wall so bad,i tried adjusting the needles to its factory settings and nothing happens,always flaming out.
Apart from the other good advice that was posted, I would also suggest that you check for a crack in the crankase. Look carefully where the engine mounting tabs join the crankcase. This happened to me. The crack made my engine impossible to tune.
Mudblaster is offline  
Reply