R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 04-14-2008 | 01:54 AM
  #2325  
RETRO RC's Avatar
RETRO RC
Tech Addict
 
Joined: Jan 2007
Posts: 715
From: AUCKLAND NEW ZEALAND
Default

Originally Posted by joeling
Hi guys,

I am a newbie to nitro & I have been running a GO 5 port for the last couple of months. Recently, I installed a turbo head button & was pretty happy with the increased power. However, I have run into a little tuning problem. After running for a while, the engine sputters & there's even a loud 'pop' from the exhaust. What could be the cause of this? I measured the head temperature & it was less than 100 deg C. On top of that, I am getting 'sticky throttle' in that the engine is slow to rev down. I know that without further details, it's not easy to figure out what is (are) the problem(s) based on this simple description. Some educated guess would be appreciated. I have just changed a new fuel tank & new tubing because I was getting the 'sticky throttle' earlier so I hope that potential area of concern is eliminated.

Regards,
Joe Ling
sounds to me like your rich down low and your idle is to high to compansate try setting the idle gap back to about .7mm to 1mm then retune the LSN hope this helps

Adrian
RETRO RC is offline