Originally Posted by
1995 Monster T
You answered your own question. You need a s-bus servo to add channels above 4. The manual show how to program the servo. This is why I hate Futaba. You have to buy expensive special servo to get more channels.
This is the reason why I'm looking at the flysky noble4 pro It can use up to 12 channels before I I need to use the i-bus for 6 more channels max 18 channels. I don't need all that junk on a radio that I will never use.
You are very ignorant aren't you? Maybe you should step out of your own world and learn something.
smanders
Microsoft Word - SBUS Decoder.doc (frsky-rc.com)
It says it can be programmed by the Futaba SBC1, that is an external programmer. Then I would say the transmitter would also be able to prgram it.
Otherwise you can look at this:
Jhemcu spp 8ch signal converter module support sbus ppm pwm output for receiver Sale - Banggood.com
No programming needed but it does just put out all channels like a normal receiver.
If speed is no issue you can also take a look to the S-FHSS receivers which can be found up to 8 channels
TxRxList_Updated-RX-HIGHLIGHTED (futabausa.com)