R/C Tech Forums - View Single Post - Axial RBX10 Ryft!
Thread: Axial RBX10 Ryft!
View Single Post
Old 07-02-2021 | 08:48 PM
  #52  
Big_Show's Avatar
Big_Show
Tech Regular
iTrader: (3)
 
Joined: Aug 2016
Posts: 438
From: Ohio
Default
Originally Posted by Wermart
I’ve been looking to buy Ryft and my friend got it first. So far he took it out 3 times and every single time he breaks rod end, and looses inner shaft. He drives it normal no abuse but quality of some plastic parts wishing be better.
Is it pretty normal that rod ends breaks on all bumps and jumps? What do you use as metal replacement?
Team Associated 81399 RC8B3 Rod Ends 4 mm. To make the rods short enough I had to cut the rod end down where the rod threads in. I cut like 1/4 off. I had to buy 3 sets to do the whole Ryft. 2 in each pack are of set, I put them on the lower front rods to gain a little ground clearance. Other 2 offset ends I put on rear rods at the top of the rear axle housing. You use the balls out of the stock ryft arm ends. 8 batt packs no breaks.
Big_Show is offline  
Reply