Originally Posted by
strodedawg
Took the Et410 out for a full practice day and slowly dialing it in. The track is a high traction clay and was looking for other peoples set ups to compare to what I am doing. Also I am running a HW xr10 pro and 4pole 4300 kv, what esc settings, motor timings and gearing sre people running? It had amazing power but ran a little hotter than i liked.
I'm using the same ESC, but a Tekin Pro2 5100kV motor with an 18t pinion, temps around 115 after 10 minutes, no fan. The Pro2 timing isn't adjustable, but measured at 12 degrees on a motorlyzer. I did set the throttle rate to 20 instead of the default 30, but just to soften my heavy finger, no issues with temp at the 30 value. All other ESC settings are a their defaults.
I also run on high bite clay - see my post #625 for other setup changes from the stock setup.