Originally Posted by
MX304
I am really struggling to get corner speed. We run on tight tracks with lots of 180s. Surface is hard pack with a thin layer of dust. It starts to tun in ok, but doesn't rotate well and if you even touch the throttle it just goes straight. Pushes horribly in fast on power sweepers as well. Nothing is bent or binding. Any ideas? I'll try to attach my current setup sheet.
Can't see your rear camber link position, or the front actually. But try going up on the tower with the rear link. You can also try running less anti squat by going down on the C block or up on the D block. Down on the C is probably better in your situation as it will lower your roll center slightly.
Also your diffs seem pretty light for truggy.