Originally Posted by ricardoguro

Hi
I have a problem with my trackstar smart programing box, esc gen ii 120a and a trackstar 10.5t brushless motor.

i have this combo on my trf417 and a tamiya tt02 type s.

I usually connect the programing box to the esc, to make some setup changes, but when i go to Motor Timing, it says "push to start", so i do it and then it says " sending to esc, please wait", the esc flashes once green and the red, and the time goes on and nothing happends.

i have tried taking the can timing to the minimium value, 0 and the maximium but i can not set up the motor timing.

Also i have the boost timing and the turbo timing just stock, i do not use them

I apreciate your help with this problem, i have wrote to HobbyKing and they already sent me a new smart box telling me that was the problem; i have tried this procedure with 2 or 3 smart boxes and the same happends.

Thanks for your help