Originally Posted by
ezlight
Asked before, and no one answered, or confirmed checking.
The o-rings to seal the cap, and the one for the shock collar are in the same bags. It is possible that the wrong one was used in the wrong place. Can you guys go over these and confirm if this is the issue? The shock collar will definitely feel loose if the o-ring isn't right.
I went through my shock build last night and was paying very close attention to this in light of this discussion... I encountered the same issue. I'm not convinced it's an issue with the rings, though... it's quite possible that the collars or the bodies aren't the proper size.
At any rate, there's definitely an issue somewhere. Hopefully under load, there will be enough pressure from the spring compression to keep the collars in place, but it's not a long-term solution.