Originally Posted by
racer1812
Are you selecting the 5.5ms frame rate BEFORE you bind?
Just for you I pulled out my B6 and bound a sr3520 to test. Selected 5.5ms frame rate, Bound the Rx without a servo plugged in. No issues.
Bound again with a Spektrum 6040 servo plugged into the Rx, again no issues. Radio holds the 5.5ms frame rate on DMS2.
Bound back to my SR2000 Rx, screen switched to DSRM and 5.5ms frame rate.
Long story short, make sure you select the frame rate before binding.
Hope that helps...?
Yes, go into frame rate and select 5.5ms (16.5ms isn't even an option on my radio here) and then go to bind. Hit bind and it shows 16.5ms once the binding process is done.
I've tried it with just the ESC plugged into the receiver and with the servo and PT plugged in. Same results both ways.