Hello everyone, I could really use some guidance with setting up my Hobbywing Justock Club Spec ESC. I'm getting back into the hobby and these types of ESC's are pretty new to me. I have looked through other posts but do not see an answer to the problem I'm having. Any help that can be sent my way would be greatly appreciated.

I have the ESC in my 1/12 scale 12R5.2 running a 1 cell battery using the ESC's BEC and not running a separate battery pack. When I apply full throttle the green light comes on indicating full throttle. However, the car is moving at a pace FAR LESS than maximum throttle input. I have used the programming card to change the Cut Off Threshold to non protected as read in another post was required to do when using this ESC with a 1 cell battery.

What I have also found odd is that the program card has an option, number 12, that would allow me to select the lipo cell count of the battery I am using but the program card only operates up to option 9 and will not allow me to go to option 12 on the program card.

Do I not have something configured correctly within the transmitter such as propper end points or is there another setting within the ESC that I'm missing entirely? I've read countless posts where this ESC is being used with a 1 cell pack but I'm not certain how users were able to get it to work.

Any help regarding how to proceed would be greatly appreciated!