Originally Posted by
proliteandsc
I started with Joes Southern Nats and made a few changes.
Front arm shock mount is A.
2mm rear wheel offset.
Front shock 32.5 AE
Rear shock 37.5 AE
Diff 7,10,3 AE
Track is outside smedium dusty hard packed clay, sometimes wet. I guess about medium grip.
I tried calibers, subcultures, hole shots, crime fighters, sweeps, all about half worn.
I did notice the servo saver could be made tighter. That might help. I'll try that next time I race.
Anyone have any ideas what I need to change to get this car around wide turns? It pushes when turning on power.
My setup is very close to yours . The only thing that I have tried that eliminated the push was switching the caster blocks and trailing spindles out and running the .2 spindle/ blocks. Unfortunately this made the buggy twitchy and difficult to run clean lines so i put the .3's back on. My track is a 1/10 scale style track with 3 180s and does not flow well . How do you like that center diff at 10k?? Thinkin about goin heavier on my center diff as my front tires balloon a lot.
Last edited by carpetburner; 07-23-2016 at 02:21 AM.