Originally Posted by
Juschiln19
Hey I saw ur setup looks good want to get my like that.. what adaptor did u use for the tires. Do u have a part number maybe... I'd appreciate it thanks
Thanks
Juschiln19!
In order to achieve a better off-set for the drift set of wheels I had to use Integy hex adapters:
+18mm for the rear:
http://www.integy.com/st_prod.html?p...w#.VRAVwo7F98E
+12mm for the front:
http://www.integy.com/st_prod.html?p...w#.VRAWIY7F98E
The +12mm blue ones seem to be out of stock, but they might carry them in some other color if you don't mind.
Some shims are needed to adujst the gap from the axle bearing to the hex pin in the new adapters. I have used these:
- three (at least) 6x8mm shim sets:
http://www.amain.com/product_info.ph...6x8mm-Shim-Set