R/C Tech Forums - View Single Post - Lipo Charging Wires
View Single Post
Old 08-05-2014 | 01:46 PM
  #9  
J@UNE's Avatar
J@UNE
Tech Addict
iTrader: (1)
 
Joined: Feb 2004
Posts: 641
From: Ottawa, Ontario
Default

Originally Posted by Dave H
Drawback is less accurate cell voltage reading, as 2 of 3 balance leads will have the slight voltage drop across the main wires compared to the middle balance wire. Will likely cause a bit of unnecessary balancing and slightly longer charge times. Perhaps if not using high charge rates the difference will be minimal.
Ok I get it, I just though that longer balance leads would cause more resistance. I'll just use the std config and go that route


Thanks for info!!!
J@UNE is offline