Originally Posted by
thesmogman
Thanks for your response Randy... It just seem's like one time it is a rabbit out of the hole then it just is off a little the next.
Spectrum dx2 throttle set up pretty much stock 100epa's and such for the transmitter. On the esc same here too flat throttle curve, no timing, Started out with 8 for cl and have been moving it up to get some torque for the short run to the triples. I think 1 or 2 drag brake.
I haven't updated the firmware I believe running 248. Running SMC 2s 5600 70c lipos. Green bar codes. Pretty much stock as far as the truck is concerned. Diff's w/center diff and shock oil and springs have been adjusted but that is it. Truck's drive system is in a very good condition, just changed out all bearings.
Comments at the track are smooth and quiet. If you have any suggestions I am all ears.
Are you sure it's "8" on the CL? If so bump that to at least 50 to get started.
Also update to 250 esc software. Leave all the exp and throttle profile linear for now until we can get the power delivery set up for you.