Originally Posted by cannonballs

I got a issue, maybe ya'll can help. I have the traction drive installed. It works amazingly. Just that it get hot, and It should as it allow the clutch to slip. My issue is the set screw keeps coming lose. I've tried several different spring tensions and that doesn't effect it any. I've also tried different lock-tight. I understand that heating up lock-tight will break it down and actually causing it to lube the screw. Is there a high temp lock-tight? What can I do to keep this from coming loose and backing down the shaft? I thought about drilling a hole in the shaft and using one of those set screw/pin. But I scared that will weaken the shaft.