R/C Tech Forums - View Single Post - Official Tekin RX8 GEN2 ESC Thread
Thread: Official Tekin RX8 GEN2 ESC Thread
View Single Post
Old 01-15-2014 | 01:16 PM
  #1675  
Randy_Pike's Avatar
Randy_Pike
Team Tekin
iTrader: (6)
 
Joined: Nov 2007
Posts: 9,912
From: Norcal
Default
Originally Posted by MX304
I did that. Twice actually. When I have it plugged in via the Hotwire the motor selection is correct. I also tried changing the firmware version to see if that made any difference. I just hooked my Gen 1 RX 8 up to the same motor and receiver and it works fine.
Ok, that narrows it down right there. If the Gen1 works and the Gen2 doens't and you're sure the settings are right, it's bad.

Please contact [email protected] The guys will take care of you.
Randy_Pike is offline  
Reply