R/C Tech Forums - View Single Post - Official Tekin RX8 GEN2 ESC Thread
Thread: Official Tekin RX8 GEN2 ESC Thread
View Single Post
Old 12-21-2013 | 11:21 AM
  #1603  
Randy_Pike's Avatar
Randy_Pike
Team Tekin
iTrader: (6)
 
Joined: Nov 2007
Posts: 9,912
From: Norcal
Default
Originally Posted by Blindhog
I just purchased a RX8 Gen2 ESC with the 4600 Tekin Pro4 motor combo. Got it all wired up, calibrated the radio and everything working fine. Took it out to the street for a test run and it went dead. LED 1,2 / 6,7 blinking. I have the HotWire setup, so I checked the motor type; Type 3. All other settings are stock/default.
I tried the Type 4 motor setting, no effect.
So what is my next course of action?
BTW, checked the data log and everything went to full stop at around 3 minutes. Battery still showed good and motor temp normal.

Thx,
Hog
since it's a fresh install make sure you check the A B C wires for good connection and clean solder joints.
Randy_Pike is offline  
Reply