Originally Posted by
rc car guy
im not entirely sure but im fairly certian your new... haha first thing is first. make sure you steering links are the same, after that make sure your servo horn is where its suppose to b e(with full epa and no sub trim(if your using regular trim gtfo)) next back you steering off until they dont hit the hubs on either side( via epa) ... after that adjust the small link until your epa is off by 5 or less. make sure it drives a straight line if not adjust sub trim to go striaight. Now go turn some circles visually measure them to be about 3 in of less apart. if not adjust epa accordingly (make sure it doesnt hit the hub).
I'm new to the b4 and 1/10 buggy in general, but have built several FT kits including the SC10 so it was a really similar build. I got the horn lined up and trimmed and and used calipers to set links, and all that good stuff, my issue is that the max travel is blocked when the arms are in full droop as set per the instructions, but I get another 5% or so when the arms are level.
I'm fairly sure that I build something wrong, but just wanted to check if this was normal and just needed to set epa at full droop instead.