Originally Posted by
boborc
I talked to Charlie and it is rated for 4 pole motors, he says its probably a bad solder joint or something causing a huge draw I just hope i'm not getting the run around everybody blames the others equipment. I just want to solve the problem how ever I need to. Searching around though I have even seen racers with rx8 having the same problem so I'm going to try rewiring and swapping the servo. I do use those 3.5mm bullet connectors on the motor wires does anyone know if that's a good idea??
I wouldn't use 3.5mm bullets unless they were castle brand. I've seen alot of motor problems on my buddys rigs because he insists on running cheap bullets because he's to lazy to do his own soldering. He always runs the cheap bullets and they just dont last and his motors cut out all the time but he still runs them.